Restore integrity without a full tear-out.
A cracked or pitted slab does not always mean it is time for a tear-out. Plenty of concrete around the Front Range is still structurally sound under the surface, with a base that is fine and steel that is doing its job. The problem is on top: a crack working its way across the field, an edge that has spalled and flaked, or a section that has lifted just enough to catch a toe or a snow shovel. When the bones are good, repair restores the slab to safe and solid for a fraction of what new concrete costs.
The catch is that not every repair is worth doing. A surface crack from normal shrinkage is one thing. A crack that keeps widening because the soil under the slab is moving is another, and patching that one just hides the real problem until next spring. We look at the slab, figure out what is actually driving the damage, and tell you straight whether a repair will hold or whether replacement is the smarter spend. That honest read is the whole point of calling us first.
Steep, rocky ground makes grading and drainage the heart of the job. We plan both before we form. For concrete & crack repair, that local knowledge is exactly what protects your investment. We plan the base, drainage, reinforcement, and finish around the conditions on your Morrison property, not a generic detail.
We serve every part of Morrison and the surrounding area, including Willow Springs, Friendly Hills, Red Rocks area. Wherever you are in Jefferson County, the crew shows up with the same standard.
At roughly 5,764 feet, Morrison gets intense high-altitude sun and a freeze and thaw cycle that is hard on any concrete poured without care. For concrete repair, that means air-entrained mixes, deliberate curing, control joints cut on time, and a base prepared for the expansive clay under your property. It is the difference between work that holds for decades and work that starts failing by the first or second spring.
A crack is information. The width, the direction, whether the two sides sit level or one has dropped, all of it tells us why the slab failed. Hairline shrinkage cracks that show up in the first year are cosmetic and seal up clean. A crack that runs corner to corner, opens wider at one end, or has a lip where one side sank is telling you the ground moved. On our expansive clay, that movement is usually water getting under the slab and swelling the soil, then drying and shrinking it back. We trace the cause first. Sealing a moving crack without fixing the drainage or the void underneath just buys you a few months before it reappears in the same line.
Once we know a slab is worth saving, the repairs themselves are straightforward. Active cracks get routed out to a clean channel and filled with a flexible polyurethane or epoxy that moves with the concrete instead of popping back out the first cold snap. Spalled and flaked surfaces, the kind road salt and freeze-thaw chew into driveways and steps, get cut back to sound material and rebuilt with a bonding repair mortar. Raised edges and lifted joints that snag feet come down to a safe transition, either by grinding the lip or lifting the low side. The goal every time is a surface that is safe to walk, sheds water, and does not keep eating at itself through the next winter.
This is the question worth asking, and the honest answer is: it depends on what caused it. If a crack came from normal shrinkage or a one-time event and the slab is otherwise stable, a proper rout-and-seal repair holds for years. If the crack is the symptom of soil that keeps swelling and shrinking under the slab, then filling it alone will not last, and we will tell you that up front. In those cases the fix is the cause, correcting drainage so water stops collecting under the concrete, filling the void if the slab has lost support, and only then sealing the crack. We would rather quote you the repair that actually lasts than the cheap one that sends you back outside next March with the same line opened up.
Repair is not always the right call, and we will say so. If a slab is spider-cracked across the whole field, has multiple sections that have heaved or sunk, or has crumbled deep enough that there is no sound concrete left to bond to, you are throwing money at a surface that is going to keep failing. At that point a partial slab replacement or a full tear-out and fresh pour costs less over the life of the concrete than chasing repairs every season. We give you the repair-versus-replace read as part of a free estimate, with the reasoning behind it, so you are deciding with the same information we have, not just taking our word for it.
Every Morrison job starts with a free, written estimate and a structural engineer on staff for the work that needs one. Licensed, bonded, and insured, with finishes from a clean broom texture to stamped, colored, and sealed.
You always know what is happening and what it costs before we mix a single yard. Here is the path from first call to final walkthrough.
We visit the site, measure, check drainage and soil, and hand you a clear written quote. No charge, no pressure.
We set the grade, thickness, reinforcement, and finish. Structural work gets engineered and permitted.
Forms, rebar, and a clean pour. We screed, float, and finish to the texture you picked, then cut control joints.
You can walk it in 24 to 48 hours. We walk the job with you and explain how to care for it through the first winter.
Still unsure about something?
Call the crew at (303) 569-4046 and we will talk it through.
Get a free, no-obligation estimate from a crew that knows Colorado soil, Colorado weather, and how to finish concrete that lasts.
Accessibility
Adjust the site to fit how you read and browse. Your choices are saved on this device.